To start - Mike got his hands on a light fixture that wasn't being used. So of course we put it to good use! Here's what it took to get it hanging:
1. Take down the current light fixture plate and pull the wires out of the hole. To pull the wires out of the hole (as in picture #3) I had to hold the light fixture while Mike pulled out the wires.
#2: Detach the light fixture wires from the ceiling wires. To do this, you take off the red caps. This is the where the wires twist together. Untwist the wires so it looks like the picture below (and don't lose the red caps!) Also make sure you're taking note of what wires connect with what.
#3: On the new light fixture, thread the tube along with the bracket and nuts through the wire. It should look like the picture below - but I'm sure for every light fixture there's a variance so read the directions!
#4: While one person holds the light fixture, the other needs to thread the wires through the bracket still on the ceiling. This was how our old light fixture was attached so we didn't install that ceiling bracket. You can see in the picture that the wires go up into the hole and back down.
#5: Connect the light fixture wires to the ceiling wires. Just as you detached the wires to begin with, you need to attach them again. Simply twist the corresponding wires to each other. This is where remembering the correct pairing of wires comes in handy. After you twist them together, put the red cap over the attachment.
#6: Push the wires back into the ceiling. It should look like the picture below (Make sure your wire connections are secure).
#7: Secure the light fixture plate to the ceiling. Ours secured with a screw, but again, I'm sure it depends on the light fixture.
#8: Enjoy!